Summit Line

Garmin how-to · Watch settings

Garmin Watch Settings for an Ultramarathon

The best Garmin settings for an ultramarathon come down to one tradeoff. More satellite systems give a cleaner track and use more battery. The modes are GPS Only, All Systems, All + Multi-Band, Auto Select and, on some models, UltraTrac. Pick the most accurate mode whose battery figure in your owner's manual still beats your slowest realistic finish time.

By Jared Furubotten, founder of Summit Line. I started running in April 2025 and I'm training for the San Diego 100.

The short answer

At a glance

Satellite modes
GPS Only, All Systems, All + Multi-Band, Auto Select, UltraTrac on some models
Tradeoff
Accuracy against battery
Course aids
ClimbPro, PacePro, Stamina
50K
Most modes last the race. Test with a long run
100 mile
Needs a battery plan before race day
Charging mid-race
Test it on a short activity first
Source
Garmin owner's manuals
Checked
November 2026

The one tradeoff behind every setting

Your watch can listen to more satellites for a better track, or fewer for a longer battery. That is the whole decision. Garmin's manuals say the same thing in their own words. All Systems performs better in difficult environments and acquires position faster, and it drains the battery faster. All + Multi-Band gives more consistent tracks. Auto Select lets the watch choose, and Garmin says it gives the best accuracy while prioritizing battery.

I have finished four 50Ks and two 50 milers, and I am training for the San Diego 100 on April 30, 2027. The longer the race, the more this tradeoff matters. Below are the satellite modes and the battery hours straight out of Garmin's owner's manuals, and a setup list you can check against your own model.

The satellite modes, by their real names

In the Forerunner 970 manual the setting is under the activity's settings. From the upper right button you open Activities, pick the activity, open its settings, and choose Satellites. Menu names can differ by model, so check your own manual. The options in that manual are these.

  • Off turns the satellite systems off for that activity.
  • Use Default follows your default setting.
  • GPS Only uses the GPS system alone. In every battery table below it gets more hours than the other regular modes.
  • All Systems adds other satellite systems. It acquires position faster and drains the battery faster.
  • All + Multi-Band uses multiple frequency bands and gives more consistent tracks with fewer multipath errors.
  • Auto Select uses SatIQ technology to pick the best multi-band setup for where you are.
  • UltraTrac records track points and sensor data less often. It extends battery life and lowers recording quality. Garmin says it suits long activities.

Not every model offers every mode. The Forerunner 255 battery table lists All Systems and has no Auto Select row, and the Forerunner 965 table lists UltraTrac. The Forerunner 970 offers UltraTrac in its satellite settings, but its battery table gives no UltraTrac figure.

Battery hours from Garmin's manuals

These are Garmin's own "up to" figures from the owner's manuals, in hours, in GPS activity mode. The Forerunner 965, 265 and 255 figures are with wrist heart rate on. Real life runs lower in the cold, with the screen on, with music, or with notifications. Checked November 2026 against the battery pages for the Forerunner 970, Forerunner 965, Forerunner 265, Forerunner 255, Enduro 3 and fenix 8.

ModelGPS OnlyNext mode upAll + Multi-BandLong-activity mode
Forerunner 9702623 (Auto Select)21Not in the battery table
Forerunner 9653122 (Auto Select)19UltraTrac: 34
Forerunner 265 / 265S20 / 2416 / 18 (Auto Select)14 / 15Not in the battery table
Forerunner 255 / 255S30 / 2625 / 20 (All Systems)16 / 13Not in the battery table
Enduro 312080 (All Systems)60Max. battery GPS: 210
fenix 8 AMOLED 47 mm4738 (All Systems)35Max. battery GPS: 81
fenix 8 AMOLED 51 mm8468 (All Systems)62Max. battery GPS: 145

Where a cell shows two numbers, the first is the larger case and the second is the S size. The fenix 8 rows are with gesture wake, and Garmin lists lower numbers with the screen always on. The Enduro 3 and fenix 8 also list expedition modes with far longer figures. The Enduro 3 manual gives Expedition GPS as 77 days and the fenix 8 AMOLED 51 mm gives 31 days. Read what those modes record in your manual before you count on one for a race.

The accuracy side of it

On a trail with trees, canyon walls and switchbacks, a watch with fewer satellites can wander. All + Multi-Band is meant to fix that, and it costs hours. Look at the Forerunner 970 row. GPS Only is 26 hours, All + Multi-Band is 21. That is 5 hours of battery traded for a cleaner track. On a 50K that trade is easy. On a 100 miler it can decide whether the watch makes it to the finish.

Pace and distance on a long day do drift. The pace by effort guide covers running by effort and not by what the watch says every mile.

ClimbPro, PacePro and Stamina

These three are the Garmin features I would set up before a trail race. The descriptions below come from the fenix 8 owner's manual. Your model may name things a little differently.

  • ClimbPro helps you manage your effort for the upcoming climbs on a course. It needs a course loaded. You turn it on in the activity settings by setting ClimbPro status to When Navigating, and you can turn descents on or off for running activities.
  • PacePro lets you build a custom pace band from a distance and a pace, or a distance and a time. You can build it in Garmin Connect under Training & Planning, then PacePro Pacing Strategies, and send it to the watch. On the watch you can also open Activities, pick an outdoor run, then open Training, then PacePro Plans, then Create New. Pick a course, set a goal pace or goal time, and start the plan.
  • Stamina gives real-time estimates based on your heart rate data and your VO2 max estimate. The color tells you the trend. Red means depleting, orange means steady and green means recharging.

If you want paper backup for the same plan, the pace band tool prints one. And the fueling plan lives apart from the watch. Read how to build an ultramarathon fueling plan.

Ways to save battery that Garmin lists

The Forerunner 965 manual has a Maximizing Battery Life section, and every item on it is something you can set before the start. Turn off music. Lower the brightness and turn off the Always On display. Set up battery saver in the power manager. Turn off Bluetooth when you are not using connected features. Shorten the display timeout. Stop broadcasting heart rate. Turn off wrist heart rate. Limit notifications. Turn off the pulse oximeter. Use Resume Later for a long pause. Pick the Smart recording interval in System Settings. Use the UltraTrac GPS mode. Use a watch face that does not update every second.

On the fenix 8 you can also build a custom activity power mode. Hold the middle left button on the watch face and open Watch Settings, then Power Manager, then Activity Power Modes. Pick a mode or add a new one, and change settings like the GPS mode. The watch shows how many hours of battery each change gains you.

If you plan to charge from a power bank during the race, test it first. Run a short activity with your exact watch, cable and power bank, and check that the recording keeps going. Do not find out at mile 60.

A setup checklist for a 50K

A 50K is 31 miles. I ran my first one four months after I started running, and I crossed the line with 1 second left before the 9 hour cutoff. Now look at the table. Every GPS Only and All + Multi-Band figure in it is past 9 hours. So for most 50Ks the battery is not the problem. The track is.

  1. Open your model's manual and find the battery figure for the satellite mode you want. Use the lowest figure for the plan, not the highest.
  2. If the figure is comfortably longer than your slowest realistic finish, use All + Multi-Band or Auto Select.
  3. Load the course so ClimbPro works, and set ClimbPro status to When Navigating.
  4. Build a PacePro plan or print a pace band, and decide which one you trust.
  5. Turn off music, notifications and the pulse oximeter.
  6. Charge the watch the night before and start the race with a full battery.
  7. Run one long run with the exact settings first and look at what the battery says at the end.

A setup checklist for a 100 mile

A 100 miler is a different problem. Compare your own expected finish time with the table. Every Forerunner in it lists 31 hours or less in GPS Only, and the Forerunner 965 lists 34 hours in UltraTrac. The Enduro 3 and the fenix 8 51 mm list far more. If your watch tops out below your expected time, fix that before race day.

  1. Add up your realistic finish time and compare it with the manual's battery figure for your mode.
  2. If the figure is short, pick a more frugal mode such as GPS Only, UltraTrac where your model has it, or a custom power mode.
  3. Run a long training day in that mode and look at what is left. The manual's hours are an upper limit.
  4. Decide your battery plan in writing. A second watch, a watch that lasts longer, or a power bank you have tested.
  5. Turn off everything on the Garmin list above that you do not need, from music to the Always On display.
  6. Load the course and set ClimbPro, then print a pace band as backup.
  7. Back up the plan on paper, because a dead watch should not end your race.

Your plan reads your Garmin runs once they are in. If you connect, new runs sync on their own. The steps are in how to connect Garmin to Summit Line. To pull in your past runs, see how to export your Garmin data. For the training itself, there is a 16 week 50K plan and a 24 week 100 mile plan. And if you are asking whether Garmin's own coach can do this, read does Garmin Coach have ultramarathon plans.

A plan that reads your Garmin runs

Pick your race, connect your Garmin or drop in your export, and Summit Line builds the plan around your real runs and the real course. The 7 day free trial covers all of it.

Frequently asked questions

What GPS mode should I use for an ultramarathon?

It depends on your model and on how long you will be out. Garmin's manuals list GPS Only, All Systems, All + Multi-Band, Auto Select and, on some models, UltraTrac. GPS Only gives the most battery of the regular modes. All + Multi-Band gives the most consistent track. Compare your slowest realistic finish time with the battery hours in your model's manual and pick the most accurate mode that still lasts.

How long does a Garmin battery last in GPS mode?

It depends on the model and mode. Garmin lists up to 26 hours of GPS Only on the Forerunner 970, 31 hours on the Forerunner 965 with wrist heart rate, and 120 hours on the Enduro 3. These are manual figures, checked November 2026. Real life runs lower with the screen on, with music, or in the cold.

What is UltraTrac on a Garmin?

UltraTrac is a satellite setting that records track points and sensor data less often. Garmin says it extends battery life and lowers recording quality, and that it suits long activities. The Forerunner 965 manual lists 34 hours in UltraTrac with wrist heart rate. Not every model offers it.

Does Garmin ClimbPro work for trail races?

Yes, as long as the course is loaded on the watch. ClimbPro helps you manage your effort for the upcoming climbs on that course. You turn it on in the activity settings by setting ClimbPro status to When Navigating. On running activities you can also turn descents on or off.

What is Garmin PacePro?

PacePro lets you build a custom pace band from a distance and a pace, or a distance and a time. You can build it in Garmin Connect and send it to your watch, or build it on the watch under Training, then PacePro Plans. It works best on a race with a known course.

Can I charge my Garmin watch during an ultramarathon?

Test it before you count on it. Charge your exact watch from your exact power bank during a short activity and check that the recording keeps going. Do that well before race day, not at the first aid station.

Is Garmin accurate enough for a 100 mile race?

Distance on a long trail day drifts on any watch. More satellite systems and multi-band can give a cleaner track, and they use more battery. Run by effort, use the watch as a guide, and read your log after the race.

The timeline

Tracking a race? Get its week-by-week countdown: when to build, when to peak, when to taper.

One email with the timeline, plus training notes for this race. Unsubscribe any time.